Quote from: richard on October 26, 2016, 09:55:45 PMIf you where to drill lots of holes i recon you'd get a good covering.
yes there is a gap in between the van and the boards. I think filling it with expansing foam will cause more problems because some parts will have gaps and then others will have too much
Alternatively you could just put double sided foil insulation over the outside of the boards. Its about 8mm thick but if i remember rightly its the equivalent to 25mm or 50mm foam insulation. I cant quite remember which.
I'm about to do mine in the foil stuff.
Quote from: NickJ83 on October 26, 2016, 09:49:06 PM
Is there space behind the ply boards?
If there is a gap you could look at injecting foam insulation via some drilled holes.
Putting insulation over the boards I'd imagine would lose a lot of space and you also risk condensation on the steel
Sent from my SM-N910F using Tapatalk
Sent from my SM-N910F using Tapatalk